‎11-15-2022
09:40 AM
657 Views
jfix
Contributor I
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm using FlexGUI to program my PMIC. I'm setting it up for use in production. I would like to take advantage of the "Use this configuration and do not ask again" that appears at the bottom of the Launcher. This will eliminate an extra click for the operator. However, it doesn't seem to work. What am I missing?
Solved! Go to Solution.
1 Solution
‎11-15-2022
11:35 AM
644 Views
ErikaC
NXP TechSupport
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please try to run the restore defaults that are in the same folder and try again, I already tested it and it works fine for me.
I hope it helps.
Best regards.
1 Reply
‎11-15-2022
11:35 AM
645 Views
ErikaC
NXP TechSupport
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please try to run the restore defaults that are in the same folder and try again, I already tested it and it works fine for me.
I hope it helps.
Best regards.