FS26 does not reset when it is supposed to

[Albatros]

Hi,

I am using Sbc_fs26_example_HLD_S32K344 example code. I can successfully drive the FS26 into normal mode. However, when FS26 does not reach to my microcontroller (S32K344) it does not reset my board. For example, when I create a while loop, fs26 is supposed to reset my board. Why it does not reset my board?

Note : When i read the value of WD_FS_REACTION[1:0] bits i saw that it is 2.

[guoweisun]

For your while loop,what's it function? why do you need reset your board?do you mean reset by RSTB pin?

[Albatros]

With a while loop, I tried to act like my code was stuck somewhere. I expected fs26 to reset the board in that time but it didn't.

[guoweisun]

You can descript more detail for your operation ,for example the show the states of SBC,which registers did you set?Why need reset SBC and  what condition under reset SBC?