Calib state not terminated
06-11-2020
01:34 AM
1,580 Views
abderrahimjamao
Contributor III
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am trying to control my brushless motor (Gear hub motor) by the MTRDEVKSPNK144 project. It is therefore blocked in the calibrated state then goes to the fault state and indicates that the fault comes from the current Ia.
Reply
1 Reply
06-16-2020
02:35 AM
1,532 Views
marekmusak
NXP Employee
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
could you provide parameters of this motor?
Rated current In
Rated voltage Un
Rated speed n
Stator resistance Rs
Number of pope pairs pp
Reply