In the s12zvm Toolbox,the hostid cause a problem again

cancel
Showing results for 
Search instead for 
Did you mean: 

In the s12zvm Toolbox,the hostid cause a problem again

Jump to solution
296 Views
hongjinzeng
Contributor IV

Hi everyone,

    When I use the motor control toolbox for s12zvm,the error is blow:

Error evaluating <a href="matlab:Simulink.internal.OpenCallbackParamsDialog(['adc'],'InitFcn');">'InitFcn'</a> callback of block_diagram '<a href="matlab:open_system ('adc')">adc</a>'.

   I think the error is caused by the hostid,which in my machine is xxxxx,in others machine is xxxxxxxx.I need the new 'mcd_s12z_hostid.p' file and  'mcd_s12zvm_hostid.p' file.

1 Solution
115 Views
constantinrazva
NXP Employee
NXP Employee

hi zenghongjin@chegustech.com‌,

I attached here the mcd_s12zvm_hostid.p file. Before you copy the new .p file please rename the old one as mcd_s12zvm_hostid.p.old.

Please copy the mcd_s12zvm_hostid.p file into the following folder :

{Toolbox install dir}\mctbx_s12zvm\mctbx_s12zvm\mscripts\

Please let us know if you have further issues with this.

Kind regards,

Razvan.

View solution in original post

1 Reply
116 Views
constantinrazva
NXP Employee
NXP Employee

hi zenghongjin@chegustech.com‌,

I attached here the mcd_s12zvm_hostid.p file. Before you copy the new .p file please rename the old one as mcd_s12zvm_hostid.p.old.

Please copy the mcd_s12zvm_hostid.p file into the following folder :

{Toolbox install dir}\mctbx_s12zvm\mctbx_s12zvm\mscripts\

Please let us know if you have further issues with this.

Kind regards,

Razvan.

View solution in original post