MPC5744P SPI Continuous Selection Format

キャンセル
次の結果を表示 
表示  限定  | 次の代わりに検索 
もしかして: 

MPC5744P SPI Continuous Selection Format

782件の閲覧回数
文辉王
Contributor III

Hi,

Now I need to set the SPI to continuous communication mode. What should I do?

regards,

Vern

タグ(1)
2 返答(返信)

553件の閲覧回数
davidtosenovjan
NXP TechSupport
NXP TechSupport

Hi, Continuous SCK is enabled by setting the CONT_SCKE bit in the MCR. Continuous SCK is only supported for CPHA=1.

Please pay attention to section 49.4.5 Continuous Serial Communications Clock:

https://www.nxp.com/docs/en/reference-manual/MPC5744PRM.pdf 

553件の閲覧回数
文辉王
Contributor III

Hello,

Thank you for your answer, I have been able to send data continuously. But I just need to use CPHA = 1 continuous sending operation, is there any other way?

Regards,

Vern

0 件の賞賛