Hello everyone
MCU: MPC5741PML
email: mabdkus@hotmail.com
I want to error injection for CAN module for integration test. I configure CAN as loopback mode. I use lauterbach for debugging. I have a following CAN configs:
There is contains informations about error injection in datasheet:
I want to inject error for ERRINT from ErrorStatusRegister1. ERRINT register is interrupt flag:
I try to error injection after enter freeze mode following codes:
Thank you for answers, have a good day!
I will try and write.
Hi,
could below example be helpful?
https://community.nxp.com/t5/MPC5xxx-Knowledge-Base/Example-MPC5744P-1b-2b-FlexCAN-ECC-error-injecti...
BR, Petr