Hi Guys, I'm setting up the DCU3 graphics display and almost ready to start setting up the registers in Assembler.
Before I start, is there a seperate .PDF to explain step by step to setup the DCU3 or any other info to help me set it up and run.
I already have the PXD20 reference manual which shows me the registers for the DCU3 but not actually to setup a 640x480@60Hz display.
Any help would be very much appreciated.
Thanks guys, hope to hear from you soon.
Hi, please create new case (according procedure below) with reference to this thread.
I can send you some example codes and presentation slides. Thanks for understanding
Hi David, I just tried to get a ticket for support and I received this error:
An unhandled fault has occurred in this flow
An unhandled fault has occurred while processing the flow. Please contact your system administrator for more information.
I guess the ticket page is down.