I am using MCUxpresso 11.1 with a stock MIMXRT1060-EVK board.
Can anybody provide guidance on how to manually start gdb outside the IDE and attach to the board?
I've found the gdb executable (/arm-none-eabi-gdb), but haven't had any success in connecting to the target. I would like to be able to load the executable image via MCUxpresso, then start up arm-none-eabi-gdb outside the IDE. I expect to tell gdb "target remote localhost:<port>" but nothing I've tried seems to work.
Not sure I understand the motivation behind this. But if you want to run gdb manually (commandline, scripting), you might have a look at Tutorial: MCUXpresso SDK with Linux, Part 2: Commandline Debugging with GDB | MCU on Eclipse (is for Linux, but the same applies to Windows).
I hope this helps,
The tutorial you referenced (I see you wrote it) discusses the SEGGER J-LINK and the P&E Multilink, but I'm using the Redlink server (or Link Server, or whatever it's called--it's the debugger connection via the Debug USB port).
I can restart the Redlink server via the IDE.
[Connected on port 3025]
and it says [Connected on port 3025]. I can check port 3025:
$ lsof -i :3025
COMMAND PID USER FD TYPE DEVICE SIZE/OFF NODE NAME
mcuxpress 55346 ryu 43u IPv6 0x6b3235d17ccf19ad 0t0 TCP localhost:52087->localhost:arepa-raft (ESTABLISHED)
redlinkse 77224 ryu 15u IPv6 0x6b3235d17ccf252d 0t0 TCP localhost:arepa-raft->localhost:52087 (ESTABLISHED)
but then I start up arm-none-eabi-gdb from the command line and try
target remote localhost:3025
and gdb eventually times out without connecting. Any ideas on how to proceed?