MCUXPRESSO Can't debug with opensda with Jlink firmware
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i am debugging KW36 demo code with MCUXPRESSO , when i create a new project, it always report below error, my customer also feedback they have this problems. i also noticed there are many user feedback same issue, i tried the methods in those post, but no one does work.
attached file is source code of my project, the kw36 sdk version is 2.2.0. need great support.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Also, did you flashed some example with low power functionality before? Are you sure that your device it's not going to low power?
I also experienced something similar, but it would seem to be with certain build options as I built the SDK with all the IDE's.
Nonetheless, if you will use it with MCUXpresso, have you tried downloading the SDK just for the MCUXpresso IDE? I was able to run and debug the examples building the SDK for that single IDE. I'll keep looking for the other behavior, still could you please try this ?
Hope it helps
Regards,
Estephania