crt_emu_cm_redlink reset target without flashing
06-20-2020
07:50 AM
830 Views
lubomirbogdanov
Contributor II
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello!
I'm using MCUXpresso's crt_emu_cm_redlink from command line to flash an LPC810 microcontroller. I use the command:
crt_emu_cm_redlink -pLPC810 -vendor=NXP -flash-load-exec
This works perfectly but suppose I want to just reset the target without flashing it ... how do I do that?
Regards,
L. B.
1 Reply
06-22-2020
09:15 AM
792 Views
converse
Senior Contributor V
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't think that is possible with crt_emu_cm_redlink.