CAN TX in S32R274
I USE THE CAN at loopback mode ,BUT
always wait here
while (CAN_1.MCR.B.FRZACK & CAN_1.MCR.B.NOTRDY) {} /* Wait to clear */
/* Good practice: wait for FRZACK on freeze mode entry/exit */
the tx can't tx signal
and the rx can't receive the signal
the flexcan always in the Freeze mode?
i don't konw why
Hello,
Here on the Model-Based Design for RADAR community we handle questions regarding our toolbox or other MATLAB related questions. I think your question is best suited for the S32 Design Studio community, so my advice is to ask it there (as I can not move it myself).
As an alternative you could open a ticket for technical support here (go to 'Go to Ticket').
Hope this helps,
Iulian.