Hello Community,
I am actually optimizing/extending capabilities of one of our design and looking for any detailed information regarding different power-modes. Where can I find any information about different deep sleep and standby modes for QorIQ/Layerscape ARM processors (especially LS1 Family / LS1043A, LS1046A, LS1088A)?
What all the power conditions have to be fulfilled (power-sequencing, slew-rate, switching, ...) for the different power modes supported by ARM platform?
Best Regards,
Radek
解決済! 解決策の投稿を見る。
Look at the Chapter 13 of the LS1043a Reference Manual and Section 3.5 of the LS1043a Datasheet. These documents are available on the following page:
See the following page about the LS1046a:
Have a great day,
Pavel Chubakov
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Look at the Chapter 13 of the LS1043a Reference Manual and Section 3.5 of the LS1043a Datasheet. These documents are available on the following page:
See the following page about the LS1046a:
Have a great day,
Pavel Chubakov
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Thank you very much! This is the information I was looking for!
Sorry, one question to LS1088A. In Reference Manual Rev. D 06/2017, page 1744 is some info missing:
Please, can you tell me, what is missing there?