Hello,
I have an LPC-Link2 board with a flashed CMSIS-DAP script, but when starting debugging with the openOCD, I get an error: "Error: CMSIS-DAP command CMD_INFO failed". What could be the problem? The computer correctly detects the LPC-Link2 in CMSIS-DAP mode. I also noticed that the chip LPC4370 heats up and the consumption of the board is 200mA at 3.3 volts, is this normal?
Solved! Go to Solution.
Hi @vlad23
If the problem started when you unpackage the board please contact with your distribuitor for the warranty.
I hope your issue gets a solution.
Best Regards, Miguel.
Hi @Miguel04
Yes i get this error with any project. This problem arose from the unpacking of the LPC-Link2, it's always this error. I tried to connect a second LPC-Link2, this error does not occur on it and the debugger works.
Hi @vlad23
If the problem started when you unpackage the board please contact with your distribuitor for the warranty.
I hope your issue gets a solution.
Best Regards, Miguel.
Hi @vlad23
I'm afraid it is not normal.
Do you have this problem everytime you run any project?
This happens only when you debug your project?
This could be the board is burned.
Best Regards, Miguel.