If MCAT “App Control” tab is not displayed correctly like in the picture below, where gauges and fault indicators are missing, it is because a gauge component was not registered automatically in the windows system.
In order to fix this this issue apply following step to register gauge component:
1. Close the FreeMASTER project.
2. Extract agauge.CAB file located in C:\NXP\MC_DevKits\MCSPTE1AK344\sw\MCSPTE1AK344_PMSM_FOC_2Sh_ll\FreeMASTER_control\MCAT\control_page
NOTE: You may use any archive software with CAB archive support includes WinZip, WinRAR or 7-Zip.
3. Run command prompt as an administrator.
4. Change active directory to extracted folder cd C:\NXP\MC_DevKits\MCSPTE1AK344\sw\MCSPTE1AK344_PMSM_FOC_2Sh_ll\FreeMASTER_control\MCAT\control_page\agauge
5. Run command regsvr32 agauge.ocx.
Message box will inform you about gauge successful registration.
After gauge has been successfully installed you can open the FreeMASTER project and MCAT “App Control" tab will display correctly.