I could not enter into debug mode and there is 'Could not set PC to entry point' pop-up. I also try to debug via NXP website demo AN2892SW. That is same error. It is a old project and debug succesfully before. Debug tool and hardware board is good. I don't know what this error mean. Would you give me some direction to remove it? Thanks.
Debug tool - P&E USB ColdFire Multilink tool
MCU - MCF5234
IDE - Codewarrior V5.7
PC environment - Vmware windows XP
Hello,
Is there a way to test this situation without vmware, It seems the computer is confusing about the entry point and where is located.
Regards
I change try without Vmware. There is no error indication and could enter into debug view. But I could not step into or step over normally. I download demo AN2892SW
In addition, after download demo, there are function redeclaration build error. I undefine redeclaration function and build successfully and debug it not normally. I don't know why? Thanks.