Codewarrior Multilink Error

取消
显示结果 
显示  仅  | 搜索替代 
您的意思是: 
已解决

Codewarrior Multilink Error

跳至解决方案
923 次查看
admin
Specialist II

We are currently trying to program a XBee 868LP device using the PE Micro Multilink Interface REV C and CodeWarrior Development Studio. Both the lights on the multilink is on and the device appears in the device manager and in CodeWarrior. However, when we try to program a section of code we get the error message included in the attachments. We have tryed to reinstall the drivers for the Multilink, reinstall Codewarrior and we have even tryed 3 diffrent XBee devices.

 

Any ideas for how to fix this problem?

 

 

Thanks,

Ole K.

标签 (1)
0 项奖励
回复
1 解答
634 次查看
Jorge_Gonzalez
NXP Employee
NXP Employee

Hello Kristian:

What is the procedure you are following to program the device?

Sometimes this errors are caused because of a wrong selection of the target MCU. Have you verified with the datasheet that the device is the same as in your project?

Regards!

Jorge Gonzalez

在原帖中查看解决方案

0 项奖励
回复
1 回复
635 次查看
Jorge_Gonzalez
NXP Employee
NXP Employee

Hello Kristian:

What is the procedure you are following to program the device?

Sometimes this errors are caused because of a wrong selection of the target MCU. Have you verified with the datasheet that the device is the same as in your project?

Regards!

Jorge Gonzalez

0 项奖励
回复