Codewarrior Multilink Error

[admin]

We are currently trying to program a XBee 868LP device using the PE Micro Multilink Interface REV C and CodeWarrior Development Studio. Both the lights on the multilink is on and the device appears in the device manager and in CodeWarrior. However, when we try to program a section of code we get the error message included in the attachments. We have tryed to reinstall the drivers for the Multilink, reinstall Codewarrior and we have even tryed 3 diffrent XBee devices.

Any ideas for how to fix this problem?

Thanks,

Ole K.

[Jorge_Gonzalez · Accepted solution]

Hello Kristian:

What is the procedure you are following to program the device?

Sometimes this errors are caused because of a wrong selection of the target MCU. Have you verified with the datasheet that the device is the same as in your project?

Regards!

Jorge Gonzalez