mc9s08dz128 eeprom being overwritten

キャンセル
次の結果を表示 
表示  限定  | 次の代わりに検索 
もしかして: 

mc9s08dz128 eeprom being overwritten

ソリューションへジャンプ
412件の閲覧回数
martinlockner
Contributor III

I am using an MC9S08DZ128 with codewarrior V10.4 and a PE Micro USB Multilink interface. My plan is to store calibration constants in the on board EEprom but what I am finding is that every time I go into debug and down load new code the EEprom is being cleared. Has anyone come across this problem and found a solution?

ラベル(1)
0 件の賞賛
1 解決策
285件の閲覧回数
ZhangJennie
NXP TechSupport
NXP TechSupport

To avoid erase eeprom when download, please follow below steps:

  1. go to debug configuration, click on "edit":
  2. then click on “advanced programming options”
  3. it will open the dialog where you can specify areas to be preserved

see attached screenshot for these three steps.

Is this what you are looking for?

元の投稿で解決策を見る

0 件の賞賛
2 返答(返信)
285件の閲覧回数
martinlockner
Contributor III

Jennie,

Thanks, that is exactly what I was looking for!

Marty Lockner

0 件の賞賛
286件の閲覧回数
ZhangJennie
NXP TechSupport
NXP TechSupport

To avoid erase eeprom when download, please follow below steps:

  1. go to debug configuration, click on "edit":
  2. then click on “advanced programming options”
  3. it will open the dialog where you can specify areas to be preserved

see attached screenshot for these three steps.

Is this what you are looking for?

0 件の賞賛