HI! I am interested in using the MC9S08DZ32 chip cause my project involves CAN interface.
I would like to do in-circuit programming and debugging. Is there a tool available to do the job?
You can use a USBDM. You can buy one here:
Hi. I am interested to find out the conections on my target board. I mean which pin of the
microcontroller is used for the debugging and how is connected to the target header?
Might consider this ultra-small USBDM.
Connection to target board throught standard 2-row 6-pin 2.54mm pitch.
Please refer to section 2.2 "Recommended System Connections" found in the MC8s08DZ "Data Sheet".
Retrieving data ...