My customer is using PF1510 for their board with i.MX6ULL.
Please find the attached file for their register settings of PF1510.
Please let me know whether if there is a concern on the settings.
On register 0x0, bits 7:3 you have 0x001111 (6-bit), but should be 0x01111 (5-bit)
On Register 0x6, bit 6 is ’1’ because LOW_SYS_WARN threshold crossed interrupt is set on register 0x28 bit 3, this is not an issue, just a warning that an interrupt was occurred.
The rest of the register setting seems correct.
Hello Jose Alberto Reyes Morales
The customer intends to do register set-up while the PMIC is in operation, (e.g. every 10mSeconds). is it OK?
Yes, in one of the "System On" states, the processor can change the values of the registers via I2C after the PMIC starts up (RESETBMCU is released).
Retrieving data ...