Is it possible to get two different frequencies say 100Hz and 200Hz from a single FTM module say FTM1 with Ch0 and Ch1.
Controller: S32K144 (64 pin package)@
Since there is only 1 counter for each FTM module so 2 PWM channels in 1 FTM have same frequency in typical. This is the case we need full PWM capability channels. If we need only something like frequency generator, we can configure
Finally, software PWM can be used if frequency is low and pulse width is big enough. Channel should be configured in output compare mode. In matching ISR, Cv is recalculated and write again.
Retrieving data ...