[JN5189 : MCUXpresso] Issues in programming via SWD

[ambika]

Hi All,

I'm using MCUXpresso to flash Jn5189 via SWD, but facing multiple issues in flashing. 

I have been facing the target detection problem till yesterday, so I tried programming via UART(However we need to use SWD programming in our final board), then I tried again SWD flashing thinking that corrupted fields of the chip could be rewritten while UART programming. Now I'm facing the below error (refer the attached image).

Could you please help me to solve this issue?

Any help is appreciated.

Thanks in Advance.

Regards,

Ambika

[Alexis_A]

This product isn't available yet. Please contact your FAE for more information about it.

Best Regards,

Alexis Andalon