Hi, there is a demo project for FreeRTOS on the KL26 that can be compiled with CodeWarrior (11.1)?
The uTasker project contains FreeRTOS solutions (requiring no porting).
See the following with KL26Z FreeRTOS UART and USB-CDC operation:
Builds with CodeWarrior, KDS, MCUXpresso, IAR, Keil, Rowley Crossworks, CooCox, Green Hills, Atollic, GCC make file, S32 Design Studio.
Complete KL26 solutions, training and support:http://www.utasker.com/kinetis.htmlKinetis KL26:http://www.utasker.com/kinetis/FRDM-KL26Z.htmlhttp://www.utasker.com/kinetis/TEENSY_LC.html
Unfortunately, you cannot use FreeRTOS on the KL26 with CW; this is due to the fact that this IDE is old and was never updated to work with what you are asking. However, I recommend you use the new IDE called "MCUXpresso" where you can use the SDK for the KL26 which has demo projects with FreeRTOS:
- MCUXpresso: https://www.nxp.com/support/developer-resources/software-development-tools/mcuxpresso-software-and-tools/mcuxpresso-inte…
- SDK Builder: https://mcuxpresso.nxp.com/en/select
Inside the SDK Builder Page, please select your board and make sure you include the FreeRTOS:
I hope this information can help you.
there is a FreeRTOS project with CodeWarrior for MCU10.1 available on GitHub here:
mcuoneclipse/Examples/CodeWarrior/FRDM-KL26Z/FRDM-KL26Z_Demo at master · ErichStyger/mcuoneclipse · GitHub
It is described as well here:
Review: New FRDM-KL26Z Board | MCU on Eclipse
It is using the McuOnEclipse Processor components (see for example https://mcuoneclipse.com/2018/09/30/mcuoneclipse-components-30-sept-2018-release/).
I have attached for you as well the project with all the generated sources so you can have a look.
I hope this helps,
Retrieving data ...