After spending a couple of hour searching for information online without luck, I decided to present my question here, we have a "Cyclone Universal" from P&EMicro, and I want to use as debugger to track some errors on our system and debug our firmware properly.
Is there any manual or detail information on how to use the Cyclone universal as debugger on KDS(Kinetis Design Studio)?, by the way we can use the cyclone as stand alone programmer without problem. I am trying to configure the cyclone on KDS but I only keep getting errors.
Connection from "127.0.0.1" via 127.0.0.1
No breakpoints currently set.
Disconnected from "127.0.0.1" via 127.0.0.1
I would appreciate if anyone could help me to solve this issue, thanks in a lot in advance.