AnsweredAssumed Answered

My kernel-4.9.88 based on evk for mfgtools got stuck

Question asked by huang zhanfei on Aug 30, 2018
Latest reply on Aug 30, 2018 by huang zhanfei

hi nxp experts:


 I'm now building a kernel-4.9.88 for mfgtools, i copy source code from yocto based on imx6sl-evk board, and make some changes( removing PMIC , adding usdhc4 for eMMC). u-boot is good for running, but kernel got stuck on the same place, please see my attached logs, and also attached my dts file, please point me where is wrong, did i cut down  too much functions?


Best regards!