AnsweredAssumed Answered

IMX7D SABRE BLUETOOTH

Question asked by syam Krishnan on Jul 23, 2018
Latest reply on Jul 23, 2018 by syam Krishnan

We are using MCIMX7 SABRE  700-28590 REV D . Successfully built image using imx-4.9.88-2.0.0_ga but not getting GUI ON HDMI,getting embedded linux splash and progress bar ,but no GUI after that.Added broad com firmware to the image and can see the bluetooth logs as below ,but on hciconfig it is always showing as .Please suggest ,how to get bluetooth UP and running.

 

hci0: Type Primary BUS SDIO

BD ADDRESS 00:00:00:00:00 ACL MTU 0:0 SCO MTU 0:0

DOWN

 

UBOOT LOGS

Bluetooth: Core ver 2.22
NET: Registered protocol family 31

Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP socket layer initialized
Bluetooth: SCO socket layer initialized

Bluetooth: HCI UART driver ver 2.3
Bluetooth: HCI UART protocol H4 registered
Bluetooth: HCI UART protocol BCSP registered
Bluetooth: HCI UART protocol ATH3K registered
Bluetooth: HCI UART protocol Broadcom registered
usbcore: registered new interface driver bcm203x
usbcore: registered new interface driver btusb
Bluetooth: Generic Bluetooth SDIO driver ver 0.1

Bluetooth: RFCOMM TTY layer initialized
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM ver 1.11
Bluetooth: BNEP (Ethernet Emulation) ver 1.3
Bluetooth: BNEP filters: protocol multicast
Bluetooth: BNEP socket layer initialized
Bluetooth: HIDP (Human Interface Emulation) ver 1.2
Bluetooth: HIDP socket layer initialized

Bluetooth: Starting self testing
Bluetooth: Finished self testing

 

Thanks ,

Sam

Outcomes