AnsweredAssumed Answered

Connect Sylvania Zigbee Bulb to gateway

Question asked by Archit Muchhal on Apr 28, 2018
Latest reply on Apr 30, 2018 by Dhvanil Patel

I am trying to connect the Sylvania Zigbee Bulb to Gateway. By following the steps mentioned for getting the EUI-64 for the Bulb, the address I have is Extended Address: 0xF0D1B8000000C50D.

 

While using 'Manual Commissioning',  I have entered this address and am getting a message pop-up as shown below - 

Device Connected

 

It says it has been commissioned successfully, but I cannot see any controls on the mobile application. The bulb is also in the discovery mode. 

Also attached is the internal board setup.

 

Regards,

Archit

Outcomes