Go to nxp.com
Where is this place located?
CodeWarrior Development Tools
to create and rate content, and to follow, bookmark, and share content with other members.
CW configurations - what are they?
Discussion created by
on Oct 25, 2008
on Oct 27, 2008 by Tom Thompson
Show 0 Likes
My CW lists two configurations: Release_QE128CLK and Debug_QE128CLK. What are the differences in these two configs? Currently, the Debug_QE128CLK is checked. After I am done, should I switch to Release_QE128CLK? How?
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Oct 27, 2008 12:46 PM
You are correct. The debug configuration has settings that builds your program for debugging. The release configuration builds your program so that it can be Flashed or burned onto a product board.
Generally, the debug configuration turns off most optimizations (so that the machine code bears some semblance to the flow of the source code), and generates symbolic information that you use to debug the program. Generally, the release configuration turns on optimizations to help reduce the code footprint or to improve performance, and does not generate symbolic information, since it's not going to be used in a shipping product.
You can adjust the settings of these configurations to suit your needs, but the default settings are usually a good starting point.
Show 0 Likes
Retrieving data ...
Freedom k64F i want to switch to openSDA bootloader mode from application mode
i.MX Development Miscellanea(i.MX 开发杂记)
i.MX6 Recovery Mode with HAB and MFG tool
How to show my customize bootlogo via HDMI
iMX7D Plugin mode HAB (High Assurance Boot)