AnsweredAssumed Answered

IAR i-jet debug TWR-K65F180 error

Question asked by Apoorva H R on Mar 15, 2018
Latest reply on Mar 19, 2018 by Apoorva H R

Like • Show 0 Likes0
Comment • 2

Hi all,

I am using TWR-K65F180 evolution board. I am facing some issues while trying to debug the code in IAR embedded workbench using IAR systems i-jet debugger. Whereas with CMSIS_DAP on-board debugger i am able to debug and load the code successfully.

My jumper settings are as below,

J32 - OFF,J20 - ON and J21 - OFF.

Connecting i-jet to J18 (JTAG) on K65 board.

IAR version 8.20 has been used for debugging.

Please help me to solve this issue.

Thanks,

Apoorva

No one else has this question

Outcomes

2 Replies

Robin_Shen Mar 19, 2018 12:37 AM
Mark Correct
Correct Answer
Hi Apoorva,

You may need to change the firmware application of your TWR-K65F180M.
Please refer the answer in "JTAG in TWR-K65F180M not functional on rev A0".

Best Regards,
Robin

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------
Like • Show 0 Likes0
Actions
- Apoorva H R @ Robin_Shen on Mar 19, 2018 12:12 PM
  Mark Correct
  Correct Answer
  Hi Robin,
  
  Thanks for your reply.
  
  I followed the procedure of upgrading J-link binary in OpenSDA boot mode.
  Still facing the same issue.
  
  Also not able to debug through CMSIS_DAP now ( Please note that i have kept jumper settings to default.
  
  How to go back to CMSIS_DAP debug mode ?
  
  Thanks,
  Apoorva
  Like • Show 0 Likes0
  Actions

IAR i-jet debug TWR-K65F180 error

Outcomes

Related Content

Recommended Content