I am using JN5168-001-M00 Module
i am reading Document like JN-AN-3113 and 3116.
I have create communication between Sleeping Device to Coordinator with major help of NXP Community.
Thank You so much for your support.
Now i just wanted to understand proper ZPS Configuration Tool.
I want to read profile ID , End Point etc.
1) I can change End Point Number in ZPS Configuration Tool it also reflects to .zpscfg file.
But i wont't be able to Read it.
whenever i change it get error Like PDUM Error because of that My RF Communication get Stop.
What i want:-
1) just wanted to read End Point ID ,Application ID or its Address of Sleeping Device.
Why i want:-
1) Because i wanted to use 20 End Point. so to recognize which End Device send data to Coordinator.
I hope you understand my Problem.
Thank you for your Time