I'm using MPC5602P, Can I use the RAppID BL for MPC5602P by selecting MCU Part No. as MPC5604P.
Yes, you can use it for MPC5602P.
Thanks for the reply. I want to implement bootloading using FlexCAN in my MPC5602P. Based on the thread I'm trying to implement this. For this is it required to have FAB = 1, ABS2 = 1, ABS0 = 0. Can't we do the bootloading without that.
Thanks and Regards,
If you want to boot micro in serial boot mode you have to follow this pin configuration:
Once again thanks for your swift response. I'm using CW Ver 2.7. I don't want to use those pins, as they are already occupied. Only FAB pin is in my control. So, I can make FAB pin 0, so that I can do Bootloading with valid boot signature. Or Is there any other way to do this?
As I have already replied to you.
If you want to use serial boot mode you have to set FAB and ABS.
Thanks for your advice. And finally I understood that my application requires Flash boot. Now I want to use RAppID Bootloader utility with CANcaseXL. What is the code flow I need to follow in my bootloader program. Do I need to develop CCP on my bootloader code.
Retrieving data ...