Correct entry point for MPC5777C

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Correct entry point for MPC5777C

1,891 Views
lucas_santos
Contributor II

Dear All,

Please,

I am developing a software for MPC5777C, compiling with WindRiver Diab Compiler 5.9.6 and debugging with iSystem winIDEA iC5000.

I am having trouble in downloading and run my program. Everytime I try it goes to some FFFF address, however my program is in RAM memory 0x4000000. 

Does anybody know how to setup the debugger to go to my entry point?

Best Regards,

Lucas

0 Kudos
1 Reply

458 Views
martin_kovar
NXP Employee
NXP Employee

Hello,

this is rather question to iSystem or Windriver, because entry point is purely software dependent. Could you please try to ask at iSystem support?

iSYSTEM - SUPPORT 

Regards,

Martin

0 Kudos