I received a demo S32K144 EVM from a NXP FTF Connects event last year and I would like to used the LPI2C module but PTA2 and PTA3 have jumper resistors that are DNP. These are R539 and R540 in this https://www.nxp.com/downloads/en/schematics/S32K144EVB-SCH.pdf document. I would also like to know the location of R567 and R568 so I can remove the jumper resistors. My issue is my board is different from the one presented online, it does not have the touch pads and the resistor mappings are different. Does anyone know the equivalent resistor numbers or have a schematic I could look at?