AnsweredAssumed Answered

How to initially program a P1020 that normally boots from MMC

Question asked by Doug Bailey on Sep 20, 2017
Latest reply on Sep 21, 2017 by Serguei Podiatchev

I am looking at the possiblity of using the P1020 in a design where it uses the mode to boot directly into a eMMC device resident on the PCB.   I have experience using this on an iMX6 and would like to apply it to my P1020 design.  

 

What I do not see on the P1020 is a mode similar to the USB boot mode on the iMX6 which allows me to boot into the MFGTool to initially load the software.  Is there a similar capability on the P1020?  

 

What is usually done to perform the initial programming for a P1020 board that nominally boots from MMC? 

 

Regards, 

Doug Bailey 

Outcomes