$ JN51xxProgrammer.exe -s COM3 -f AN1211_154_EndD_JN5179.bin
----- Error:reading chip ID-check cabling and power
Failed to read chip details on COM3
Could you please check the in the device manager that the JN5179 driver is installed correctly?
Also, if this a custom board make sure you connect the RX of programmer to TX of module and vice versaVDD, GND, SPIMISO to Ground, RESET to Ground then 3.3v.
Please let me know your findings.
Hello wu pengfei You may want to have a look here Solving Problems in Reading/Flashing JN516x Modules Regards
thinks for your help ,I am following your instructions to achieve it。
wu pengfei You are welcome Please If it worked with you mark it as correct and helpful for others searching on the same problem find the solution easily If not , comment with any other solution you found to edit and modify the document.Thanks and Regards
Retrieving data ...