AnsweredAssumed Answered

NT3H1101 Write to Registers with I2C

Question asked by Isak van der walt on Jul 28, 2017

Hi everyone

We have been trying to configure the NT3H1101 on the TAG2CLICK board.

We are only able to write to FD_OFF in the session register, any other configs we try to change at NC_REG just keeps their old value. We are able to write to the SRAM without any problems though. We can't seem to find out what is going on and wondered if anybody here knew what the problem was and a possible solution.

We are using an arduino and trying to write to the NT3H1101 via I2C.

Outcomes