MBDT code generation problem

cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

MBDT code generation problem

Jump to solution
1,107 Views
jiangfeng
Contributor III

When I do code generation in the  MBDT, [ “C:/Freescle/"CW" is not the internal or external command] appears

What's wrong with it?

Labels (1)
0 Kudos
1 Solution
867 Views
jiangfeng
Contributor III

Hi,Daniel

I have solve the problem by your suggestion, thank you very much!!

在 2017-07-11 16:26:10,"dumitru-daniel.popa" <admin@community.nxp.com> 写道:

|

|

NXP Community

|

|

You have been mentioned

by dumitru-daniel.popain Re: MBDT code generation problem in NXP Community - View dumitru-daniel.popa's reference to you

Hi Jiang Feng,

Your problem seems to be similar with this one: https://community.nxp.com/message/905868?commentID=905868#comment-905868

It looks like your operation system does not take into consideration the paths that contains spaces.

You may even reinstall the CW IDE in a path without any spaces or you could enable the 8dot3 mode on that partition.

Hope it helps!

Daniel

Participate in the conversation by replying to this email

This email was sent by NXP Community because you are a registered user.

You may unsubscribe instantly from NXP Community, or adjust email frequency in your email preferences

|

|

View solution in original post

0 Kudos
2 Replies
867 Views
dumitru-daniel_
NXP Employee
NXP Employee

Hi jiangfeng‌,

Your problem seems to be similar with this one: https://community.nxp.com/message/905868?commentID=905868#comment-905868 

It looks like your operation system does not take into consideration the paths that contains spaces.

You may even reinstall the CW IDE in a path without any spaces or you could enable the 8dot3  mode on that partition.

Hope it helps!

Daniel

0 Kudos
868 Views
jiangfeng
Contributor III

Hi,Daniel

I have solve the problem by your suggestion, thank you very much!!

在 2017-07-11 16:26:10,"dumitru-daniel.popa" <admin@community.nxp.com> 写道:

|

|

NXP Community

|

|

You have been mentioned

by dumitru-daniel.popain Re: MBDT code generation problem in NXP Community - View dumitru-daniel.popa's reference to you

Hi Jiang Feng,

Your problem seems to be similar with this one: https://community.nxp.com/message/905868?commentID=905868#comment-905868

It looks like your operation system does not take into consideration the paths that contains spaces.

You may even reinstall the CW IDE in a path without any spaces or you could enable the 8dot3 mode on that partition.

Hope it helps!

Daniel

Participate in the conversation by replying to this email

This email was sent by NXP Community because you are a registered user.

You may unsubscribe instantly from NXP Community, or adjust email frequency in your email preferences

|

|

0 Kudos