AnsweredAssumed Answered

FXOS8700CQR1 IC marking

Question asked by felicita on Feb 21, 2017
Latest reply on Feb 22, 2017 by David Diaz Marin

Hi all,

We designed our sensor board with KL46 and FXOS8700CQR1(Acc+Mag) and FXAS21002CQR1(Gyro). We got the boards working but with little accuracy issues.

We have again designed our sensor board with KL17 and FXOS8700CQR1(Acc+Mag) and FXAS21002CQR1(Gyro) following all PCB guidelines as recommended.

 

The observed issue is as follows:

Unfortunately, in our new boards (10 nos), magnetometer is not getting calibrated.

The new boards were assembled with magnetometer with IC (bought very recently) marking

263

8700

ENA

 

The same boards started working when the magnetometer was replaced with older stock (about an year old) with IC marking

263

8700

DOC

 

Does the marking on IC mean any version change?

 

It will be greatly helpful if someone can assist us in solving this issue.

 

 

Thank you!

 

 

Regards,

Felicita Mercy D.

Outcomes