AnsweredAssumed Answered

Using the FRDM-HB2000-EVM evaluation board with a function generator

Question asked by Carter Hough on Aug 11, 2016
Latest reply on Aug 15, 2016 by Fang Li

I recently purchased the FRDM-HB2000-EVM evaluation board to use for a customer demo. On page 19 of the User's guide (Doc. #: KTFRDMHB2000EVM), it illustrates the hardware configuration for using this board with a function generator rather than the FRDM-KL25Z board and SPIGen interface. I followed the setup instructions, but am receiving a 'Status Fault' and cannot seem to figure out how to activate the output. 

 

Note: I configured the board with the FRDM-KL25Z board and SPIGen interface and everything works fine.

 

Is there any additional documentation on configuring this board with the function generator?

Outcomes