AnsweredAssumed Answered

How to Set data write breakpoints

Question asked by Manish Raturi on Jul 25, 2016
Latest reply on Jul 25, 2016 by Adrian Stoica

Hi Team,

 

We are using P1010 processor in our board, we have used Chip Select 3 to map three different FPGA device. We are facing a problem, where we see once in a while the write which is intended to FPGA2 register 0x18 goes to FPGA1 register 0x18. I am using code warrior tool to debug this issue, I am unable to find the data breakpoint on the IDE. I want to stop the system whenever a particular address is written with particular value. How can I do it in 10.5.1 code warrior IDE.

 

Thanks & Regards

Manish Raturi

Outcomes