lpcware

02: Failed on connect: Em(01). Cannot find selected MEM-AP (check target power)

Discussion created by lpcware Employee on Jun 15, 2016
Latest reply on Jun 15, 2016 by lpcware
Content originally posted in LPCWare by tanmay on Mon Dec 10 04:53:02 MST 2012
Hello,
  I am using lpc1769 custom board and trying to run uIP code. but I am getting an error while debugging like

[B]02: Failed on connect: Em(01). Cannot find selected MEM-AP (check target power)[/B]

sometimes it executes but then again it gives error like

15: Target error from Read Memory: Em(11). Cannot complete transaction, even after slowing speed.

OR

10: Could not start execution from stop: Em(12). System rejected access at location 0xE000EDF0 - verify Population of memory and peripherals

15: Target error from Register access: Em(11). Cannot complete transaction, even after slowing speed.


Code works on nxp's standard board correctly.

plz help...
thanx.....

Outcomes