AnsweredAssumed Answered

JTAG_MOD

Question asked by Mathias Neusch on May 12, 2016
Latest reply on May 13, 2016 by igorpadykov

Hello,

i selected JTAG_MOD = 0 in Hardware to debug i.MX6:

 

To check the placement, a boundary scan IEEEE1149.1 will be needed.

It is not possible to populate or unpopulate the pull-down resistor at the pin JTAG_MOD.

 

Is it possible to select SJC only in Register or otherwise?

Is SW debug and boundary scan possible with the same Hardware?

 

 

thanks for your Information,

Mathias

Outcomes