I have only played around with the functions on the sensor toolbox a little, but is there a way to record the magnetic readings with the program?
If you are using the RD4247MAG3110 kit, please download and install the E-Compass Sensor Toolbox v22.214.171.124. Then you can start data recording by pressing the Start button in the Data Log frame of the GUI. For more information please refer to Chapter 9 of the E-Compass Sensor Toolbox User Guide.
It is also possible to collect raw data from generic terminal program such as RealTerm using the commands described in the attached document.
I hope it helps.
PS: If my answer helps to solve your question, please mark it as "Correct". Thank you.
Could you please specify which evaluation board and Sensor Toolbox version you are using?
I am using a LFSTBUSB interface board with the Sensor Toolbox v126.96.36.199. I purchased the RD4247MAG3110 magnetic sensor kit, and I am looking to record some of the magnetic readings using the sensor toolbox. If that is possible.
Retrieving data ...