AnsweredAssumed Answered


Question asked by Koorosh Hajiani on Jan 29, 2016
Latest reply on Feb 3, 2016 by Koorosh Hajiani

I was able to successfully built and run/debug the hello_world_twrk64f120m example project from SDK  for the KDS.

I 'm able to debug and flash LEDs however I am not sure how to display the string "hello_world" . I see in the code that UART1 is configured at 115200 bps and is used as debug port .

There is a virtual com port which on my PC is com4 and there is jumpers on TWR_k64f120m that connects the UART1's TX/RX to this virtual port.

So I set the jumpers on the board and open a terminal and nothing is displayed .

Do I need to connect to the actual TX/RX pins of the UART1 on TWR_64K120 board and then connect to the com port on my PC using a USB/RS232 jack?

This virtual com port is a bit confusing for me.


Thank you for your guidance.


Koorosh Hajiani