Hello, I'm using the USBDM_SWD_SER_JS16CWJ board, firmware version 4.12.1.
I'm trying to program and debug a custom board with an MKE02Z16VLC4 uController.
The Flash Programmer tool can detect the chip correctly, and the "Mass Erase Now" works properly.
But when I try the "Program Flash" operation, I get the following error message:
"Programming of the target flash failed!
Reason: Flash command failed (Verify, Erase, Blank check or Program)".
I have tried all sorts of configurations and Security options, no success.
Any ideas what might be wrong?
Thanks a lot!