AnsweredAssumed Answered

error when connecting K40 kinetis kwikstik by external segger jlink  using KDS

Question asked by Lijo Francis on Jan 13, 2015
Latest reply on Jan 14, 2015 by Lijo Francis

Dear Sir

I am using kinetis keikstik board.i can debug this board using internal segger jlink.Then i tried to connect external segger jlink jtag .

i make switch position (off) to use extenal jtag. applied 3v enernal jtag power.there i got error

 

launching the project encountered problem

error in final launching sequence

"

Failed to execute MI command:

-target-select remote localhost:2331 "

on console there is

"Quit (expect signal SIGINT when the program is resumed)"

please tell me solution

Outcomes