AnsweredAssumed Answered

Cannot enter background mode.

Question asked by DON PORADA on Dec 16, 2014
Latest reply on Jan 13, 2015 by DON PORADA

I'm using KDS 2.0.0 with a MK60FN1M part and a Universal Multilink FX on my own PCB.  My board worked fine with KDS 1.1.1.  I upgraded to KDS 2.0.0, and now get the dreaded "Cannot enter background mode.  Check connections."  I tried running KDS 1.1.1 with the same results.  I added the 50ms delay after reset before communicating to target with no improvement.  Tried creating a new project with the same results.

 

Downloaded CW 10.6 and made a new project.  This works.  Tried going back to KDS and got same error.

 

Anybody have any ideas?  I'm dead in the water.

 

Thanks,

 

Don

Outcomes