15:26:38 **** Incremental Build of configuration Debug for project Peak ****
make -k pre-build main-build
make: Interrupt/Exception caught (code = 0xc0000005, addr = 0x00411244)
15:26:39 Build Finished (took 170ms)
can you check if you have any breakpoints or expressions/watchpoints set?
I hope this helps,
Please tell us your project in detailed , which chip ? And bareboard ? with PE ? SDK?
Then we can help you as soon as possible .
I'm using K22 freedom board, I have the USB setup as a CDC device, RTC enabled I'm working on setting up the SPI with DMA when I started seeing this. The first time I close SDK restarted was ok for a while. It starting happen again rebooted PC still had issues close out some other programs that I run on PC and was able to compile.
Under the SDK, there is a "dspi_edma_demo" (C:\Freescale\KSDK_1.0.0\demos\dspi_edma_demo\kds), you can refer to this .
First run this demo on you board , then compare it with your project .
Wish it helps you! If you still have question, please contact me!
another strange issue unable to debug k22 freedom board or CDI hardware board base on K22 freedom
loading programming algorithm ...
Processing Object File Data ...
Verifying object file CRC-16 to device ranges ...
block 00000000-0000040F ...
block 00000420-00019B0F ...
Checksum Verification Successful. (Cumulative CRC-16=$AD31)
Target has been RESET and is active.
Disconnected from "127.0.0.1" via 127.0.0.1
Do you debug refer to the "kds_user_guide.pdf"-> 4.2 Debugging with the Kinetis Design Studio IDE ? (C:\Freescale\KDS_1.1.1\doc\pdf)
If you still have question, please contact us!
I had break points but all were uncheck what I had to do is delete all break points
Yes, you have to delete them. Unchecking seems not be enough.
Retrieving data ...