AnsweredAssumed Answered

K10 Micro controller stuck with config JTAG Disabled now NOT able to debug or update new program or erase all

Question asked by Bhuvaneshsubramanian on May 22, 2014
Latest reply on May 23, 2014 by Bhuvaneshsubramanian



For testing the Hardware behavior I just disabled the JTAG pins in CPU config and downloaded the same program to the K10 MCU after power cycle the debugger was NOT able to get connected to it, then I realized I made a mistake by Disabling those pins how to I recover it back, I just have one prototype with me to do rest of my development please suggest some workaround.



Bhuvanesh S