AnsweredAssumed Answered

How to use Match address feature of UART?

Question asked by Amit Kumar on May 20, 2014
Latest reply on May 26, 2014 by Perla Andrea Moncada Fajardo


I am using FRDM-K20D50M board with codewarrior, I am using UART_PDD, there I have set the match address to 0xA1; now when I am transmitting data(0xA1) from the terminal to the uc, it is not going to UART0_D register,  I wanted to know is their any timing diagram or any app note available which tells how to use this feature? I looked into the user manual but I couldn't get much help on this.

Thanks & Regards

Amit Kumar